Part 3 — GED ® Science · Unit 6 — Energy, Heat, Waves, Resources, and Electricity
Chapter 24A (Bonus Chapter) — Electricity: Making Charge Move Without Getting Played by the Diagram
GED® test targets: P.a.3, P.b.3, SP.7.b, SP.3.b (circuits and Ohm’s law are enrichment, not listed GED topics)
Why This Shit Matters
Electricity runs lights, refrigeration, ventilation, kitchen equipment, and a whole lot of the building around you. You do not control any of it, but you see the results every day. GED Science does not list circuits as a topic. It does test energy transformations (P.a.3) and power (P.b.3), and electricity is one of the clearest places to see both.
Everyday Example
Suppose the light in one room of a house goes out while the lights in the other rooms stay on. That does not prove the whole house lost power; one lamp, switch, or connection may be the problem. If every light in the house goes out at once, the evidence points to a shared problem, but it still does not name the cause. Match the size of the conclusion to the pattern of evidence, not to a rumor that the whole damn grid collapsed.
The Real GED Words
Electric charge is a property of matter that can be positive or negative. Like charges repel; opposite charges attract. Electric current is the rate at which charge flows past a point, measured in amperes (A). Voltage is the energy transferred per unit of charge between two points, measured in volts (V). Resistance is opposition to current, measured in ohms (Ω).
A conductor lets charge move easily; metals are common conductors. An insulator strongly resists charge movement; rubber, glass, and many plastics are insulators. A circuit is a complete path for current. A load is any device that changes electrical energy into another form, such as light, motion, sound, or heat.
What Is Actually Happening?
A basic circuit needs a source (such as a battery), a conducting path, and a load. A switch opens or closes the path. Closed means the path is complete and current flows. Open means the path is broken and current stops. Here is where people get this shit wrong: an open switch does not mean the door is open for current. It means the path is interrupted.
The load does not use up the charge. The same charge keeps circulating; what the load takes is energy. A battery changes chemical energy into electrical energy, and a lamp changes electrical energy into light and heat. That is an energy transformation (P.a.3), and the total energy is conserved.
Safety point: a damaged circuit can overheat. Report it; don’t touch it.
From the Inside to the GED® test
A GED-style question replaces the room with a data table, a diagram, or a supplied formula. You read the evidence, apply the relationship the question gives you, and keep the conclusion inside the data.
Electrical Power and Energy
Power is the rate of energy transfer, measured in watts (W). One watt is one joule per second. For electrical devices, P = VI (power = voltage × current). Energy = power × time (E = Pt).
Watch How This Shit Works — Worked Example 1
A fan runs on 12 V and draws 2 A. Power: P = VI = 12 × 2 = 24 W. In 10 seconds it transfers E = Pt = 24 × 10 = 240 J. Most of that energy becomes motion of the air; some becomes heat and sound. Energy out equals energy in.
Worked Example 2 — Reading Investigation Data
Two fictional lamps each use 10 W. Testers estimate that Lamp A gives off 9 W as heat and 1 W as light, while Lamp B gives off 2 W as heat and 8 W as light. Efficiency at making light: A = 1 ÷ 10 = 10%; B = 8 ÷ 10 = 80%. Both lamps conserve energy, since every watt in comes out as light or heat. Supported: B turns more of its electrical energy into light under these test conditions. Not supported: that B is better in every possible setting.
Enrichment — not a listed GED Science topic
Read this box if you want more. It is not required for the GED Science test.
Series circuits have one path. The same current passes through every part, and resistances add: Rtotal = R1 + R2. If one part opens the path, everything on it stops.
Parallel circuits have branches. Each branch gets the same voltage, and the branch currents add up to the total. One branch can open while the others keep working. Adding a branch lowers the total resistance.
Ohm’s law: V = IR, so I = V ÷ R. Example: 12 V across 4 Ω gives I = 12 ÷ 4 = 3 A. Double the resistance at the same voltage and the current is cut in half.
Your Turn — Guided and Independent Practice — Practice Check S24A
Guided: A heater runs on 120 V and draws 10 A. Calculate its power. Then calculate the energy it transfers in 60 seconds, and name the main energy transformation.
Guided answer: P = VI = 120 × 10 = 1,200 W. E = Pt = 1,200 × 60 = 72,000 J. The main transformation is electrical energy to thermal energy (heat).
Independent 1: A 6-V device draws 0.5 A. What is its power? A. 3 W. B. 6.5 W. C. 12 W. D. 0.083 W.
Independent 1 answer: A. P = VI = 6 × 0.5 = 3 W. B adds the values, C divides 6 by 0.5, and D divides 0.5 by 6. Common mistake: grabbing an operation before writing the formula.
Independent 2: A student claims, “The lamp uses up the electric charge.” Which evidence best challenges the claim? A. The wire is metal. B. The lamp becomes warm. C. The battery has two terminals. D. The current entering and leaving the lamp is equal in a steady circuit.
Independent 2 answer: D. Equal current in and out shows the charge is not consumed; the lamp transfers energy. B shows energy transfer, not lost charge. A and C are true but do not address the claim.
Independent 3: A researcher compares two lamp types. Lamp A runs at 6 V for 30 seconds. Lamp B runs at 12 V for 60 seconds. The researcher concludes Lamp B is brighter because of its design. What is the strongest criticism? A. Brightness cannot be measured. B. Longer trials always reduce brightness. C. All lamps are equally bright. D. Voltage and time both differ, so lamp type is not isolated.
Independent 3 answer: D. More than lamp type changed, so the design is confounded. A and C are false; B invents a rule.
Chapter Checkpoint
If you can explain a complete path, describe what a load does with energy, calculate power with P = VI and energy with E = Pt, and say what circuit data do and do not prove, you have what the GED® test asks for here (P.a.3 and P.b.3).
Unit 6 Check (Science) — Inside, Mixed, and Unfamiliar Practice
Inside independent: A news report on TV says a nearby town is building a wind farm instead of a coal-fired power plant. Name one advantage and one tradeoff of each energy source.
Answer: Wind is renewable and burns no fuel while running, but its output varies with the weather and it needs land and backup or storage. Coal gives steady output, but it is nonrenewable, releases carbon dioxide and other air pollution when burned, and mining it disturbs land (Chapter 24).
Mixed: A light bulb uses 60 J of electrical energy each second and gives off 6 J of visible light. What is its efficiency? Where does the rest of the energy go?
Answer: 6 ÷ 60 × 100 = 10%. The other 54 J each second is not destroyed; most of it becomes thermal energy (heat) in the bulb and the room (Chapters 21 and 24A).
Unfamiliar (GED-style): During a storm far away, you see a lightning flash and hear its thunder several seconds later. Which explanation fits best? A. Sound travels faster than light through air. B. The thunder was made several seconds after the lightning. C. Light travels through air much faster than sound does. D. Light needs a medium, so it is slowed by the air.
Answer: C. Both come from the same strike, but light reaches you almost instantly, while sound travels about 340 m/s in air. B misreads the cause, A reverses the speeds, and D is wrong because light can travel through empty space (Chapter 23).
Ready to move on: get all three right with your reasoning written out. If you miss one, go back to the chapter named in its answer. With three questions, our 80% study goal means all three, on your first try, without help.